Looking for track control arms? Order here

Failing control arms

In general, a suspension arm doesn’t just break. Often the rubber bearings or the balls are prone to wear and / or ageing. If it appears that the rubber bearings or the ball are worn out, they need to be replaced though. Worn balls, rubber bearings or suspension arm can be recognized by the following symptoms:

Weird, undefinable noises;

Banging sound while driving on dirt roads;

Room or a ticking sound while steering;

The car pulls to either side while driving;

The car doesn´t corner as good;

Faster wearing tyres than usual;

Suspension arms wear faster if you drive more frequently over speed bumps, dirt roads or badly maintained roads. To influence wear as much as possible, it´s recommended to drive as gently as possible or to avoid bad roads at all.

Control arm replacement

Control arm replacement is often easy and can be done by yourself. You do not need any special tools to replace the suspension arm. The costs for replacement do not have to be high either. If you replace it yourself, this is already possible for as little as £ 50. Of course, this depends on the make and type of car you drive. Spot any wear on the attachment points of a suspension arm? Then the ball joint or bushings need to be replaced. Sometimes these parts are not available separately and you have to replace the entire suspension arm. In fact, it is often the case that a complete control arm is cheaper than the individual parts.

When replacing a suspension arm, all parts around need to be removed. Place your car on a car lift or car jack and remove the wheel. Then loosen the nut that secures the ball joint to the knuckle. Now you can push the arm down with a lever and remove the ball joint. Loosen all screws and other fixings and remove the arm.

Buying track control arms

Does the track control arm of your car need to be replaced? Then you can easily order one at Winparts. Just enter your number plate on the website and the right products for your car will be displayed. Of course, it goes without saying that you can also find control arm bushings and ball joints at Winparts.

Track control arms

A control arm, also known as a suspension arm or A-arm, is part of the suspension of your car and ensures that the wheels can move. It ensures that when you turn the steering wheel, the wheels can hinge over the ball joint. Replacing your track control arms is necessary when the control arm bushings and ball joints are worn. If this is applicable to your vehicle, you will notice that the car is no longer steering nice and tight. You can order new suspension arms easily at Winparts. Just perform the number plate check and find the right products for your car.

24201 - 24220 / 24306 products

Filter

0 filters selected

Block view
List view

Wishbone, wheel suspension 104939 FEBI

Fitting Position: Front axle right (driver's side)
Steering arm type: Control Arm
Material: Aluminium
Supplementary Article/Info 2: With ball joint, With bearing(s)
Supplementary Article/Supplementary Info: With locknut
Observe service information
Warranty: 2 years
Part other side: 104938
Cone Size 2 [mm]: 19
External Thread Size: M12 x 1,5
Cone size (mm): 14,5
Weight [kg]: 2,58