Mudguard

Rotating wheels can create a spin effect, causing stones, road salt, dirt and moisture to splash up while driving. This dirt can be very damaging to the body of the car. That's why every wheel of the car has a mudguard. These mudguards are the inner fenders of the wheels. These inner fenders are made of a high quality plastic, so they will not rust or break quickly. The mudguards collect moisture, dirt and other splashing influences and ensure that these are removed. These mudguards therefore provide good protection for the bodywork.

Mudguard broken

In general, the mudguards will last a car lifetime. However, various situations can occur that cause the wheel arch to break. For example, a collision can occur or cracks can occur around the fastening screws. When the mudguard is broken, it can hang loose and rub against the wheel. This is of course very bad for the wheels and also causes an annoying noise. In addition, the bodywork will no longer be properly protected against splashing dirt and moisture, which can lead to corrosion. Therefore, make sure that you replace a defective inner fender in time.

Replace mudguard

Replacing the mudguard is not a difficult job and you can easily do it yourself. You can observe the following steps:

1. Jack up the side where you want to place the new mudguard with a car jack or bottle jack. Support the car with axle stands so that the car is stable and you can work safely.

2. Remove the wheel so that the wheel arch is easily accessible.

3. Clean the wheel arches with a high-pressure cleaner, so you can see where the mounting points of the mudguard are located. In addition, the wheel arch is now nice and clean for use again.

4. The inner fender is secured with a number of screws and plastic mounting clips. You can remove this and the mudguard will be easy to remove.

5. Install the new mudguard. It is recommended to replace the old screws and the mounting clips with new variants. The old variants will probably be rusted or worn out. With new mounting parts you ensure that the wheel arch can be fastened properly and firmly again.

6. Finally, you can reassemble the wheel and lower the car again.

Buy mudguard car

Buying a mudguard for your car is quick and easy at Winparts. With your number plate or car model you will quickly find the suitable wheel arch for your car. Are you looking for other plastic parts? At Winparts you will also find jack support plates, decoration trims, mud flaps and air conduction.

Fit guarantee, show parts suitable for your vehicle.

Enter your number plate or select your vehicle.

Mudguard

The mudguard is a plastic part that is placed around the wheels, on the inside of the body. The mudguard is therefore also called the inner fender of the wheel arch. While driving, a lot of stones, moisture and dirt will splash up from the wheels. This moisture and dirt must be received and received so that it does not damage the bodywork. This is also the function of the mudguard. Over time, the mudguard can be caused by damage and will need to be replaced. The inner fender is a vehicle specific part. With your number plate or car model you will find the right variant for your car.

1 - 20 / 1065 products

Filtered by: Assembly area: Front left (passenger side)

Clear all filters

Filter

0 filters selected